|
|
|
View Cart
|
Micro-Trak VHF Antennas These SMA antennas are all compatible with all the Micro-Trak transmitters. 
Micro-Trak V1, V2, V4, and V5 Rubber Duck AntennasThese factory made antennas will work with all Micro-Trak transmitters, as well as any handheld radio with an SMA antenna jack. The V2 is longer with a sturdy whip, while the V4 is more compact and flexible. The V5 antenna combines the length of the V2, with the flexibility of the V4. The V1 is shorter and sturdy.
Micro-Trak VHF Antenna V7The Micro-Trak VHF Antenna V7 is a telescoping half-wave antenna with an SMA connector. It has been tuned for 144.39 MHz, but should work well over the entire 2-meter band. The bottom is a flexible spring to reduce torque on the radio SMA connector. The extened length is 24 inches and the collapsed length is 6.5 inches. Gain is 3 dB. 
Micro-Trak VHF Antenna V7 - $30.
Micro-Trak VHF Antenna V3The Micro-Trak VHF Antenna V3 is a factory made external VHF antenna with a "Hershey-Kiss" magnet mount base for use with many hand held radios, and the Micro-Trak APRS transmitters. This antenna whip is very flexible. If using a Micro-Trak in a vehicle, an external antenna, such as this one, is highly recommened. Specifications Frequency: 144-148 MHZ Gain: 3.0dB Length: 20 inches Weight: 2.7 ounce Connector: SMA Male Cable: RG-174 10 feet Magnet Diameter: 1.25 inches
Micro-Trak VHF Antenna V3 - $19.
Micro-Trak VHF Antenna V6The Micro-Trak VHF Antenna V6 is center fed 2-meter dipole antenna that comes with a 12" SMA coax. The overall length is 37 in and the elements are flexible spring-steel 0.032 music wire. Antenna weight without coax is 0.4 oz. The wire ends are rolled into a loop and plastic coated for safety. The center feed section is epoxy or rubber coated. It provides a considerable signal boost over the rubber duck alternatives, and was primarily deisgned for high altitude balloons.
Micro-Trak VHF Antenna V6 - $40.
|