Radio/Power Interface Cables

HT / Handheld Radio Interface Cables

These cables can interface a TinyTrak or PicCon to many common handheld amateur radios and a 12V power supply.

Mobile Radio Interface Cables

These cables can interface a TinyTrak or PicCon to many common mobile amateur radios and a 12V power supply.

Computer Interface Cables

TT USB

The TT USB cable will connect a TinyTrak3Plus, TinyTrak4, or MT-RTG to a computer USB port for configuring and operating. In addition, if the TinyTrak is set for 5V on J7 (TT3+) or JP6 (TT4) to power a Byonics GPS, the TT USB will also provide the USB 5V to power the TinyTrak. It is essentially a USB A to DB-9 female RS-232 serial adapter plus a F-F null modem cable, with the bonus of providing 5V to power the TinyTrak via pin DB-9 4. Note: The TinyTrak or MicroTrak should NOT be connected to 12V when using the TT USB.

DownloadUSB cable drivers - v1.7

Add To CartTT USB - $20


USB-2.5 Cable

The USB-2.5 cable is used to configure MicroTrak and MicroFox devices with a 2.5mm stereo programming jack. It is a USB A to 2.5mm / 3/32" stereo TRS plug that internally contains the needed USB to RS-232 serial adapter. This cable was previously called the AIO USB cable. Drivers available above.

Add To CartUSB-2.5 Cable - $20


F-F Null

The F-F Null is a combination female DB-9 to female DB-9 gender changer and null modem adapter. It is used to connect a TinyTrak3 or TinyTrak4 to a standard DB-9 male computer serial port for configuration or operation.

Add To CartF-F Null - $8


TT4 Serial Splitter

The TT4 Serial Splitter will split the 2 serial ports available on TinyTrak4 J2 to two separate DB-9 connectors. The computer side is the primary port, contains a null modem adapter and will plug directly to a DB-9 male computer serial port. The GPS side is the secondary port, will plug directly to the serial DB-9 plug on a Byonics GPS , and carries the GPS power on pin 4.

Add To CartTT4 Serial Splitter - $15


DB9-2.5 Cable

The DB9-2.5 cable is used to configure MicroTrak and MicroFox devices with a 2.5mm stereo programming jack. It is a female DB-9 to 2.5mm / 3/32" stereo TRS plug adapter that can be used with any computer serial port or standard USB-to-serial adapter, but not the TT USB above. It can also be used to connect a Kenwood D710A, D700A or D7A APRS radio to a computer. Wiring is female DB-9 pin 5 to 2.5mm shield, pin 3 to ring, and pin 2 to tip. This cable was previously called the AIO Serial cable and the Kenwood D700A/D7A Serial Cable.

Add To CartDB9-2.5 Cable - $15


Back Back to the full Byonics product line